Tag: touch

Setonix Synth Marsupial – DIY Build

Setonix Synth Marsupial - DIY Build

Following up our last build of the Setonix Synth Boing!, we decided it was time for another back to back build of their Setonix Synth’s newest module, Marsupial. What is it you ask? 

The Marsupial is a dual VCF module that is based around the re-issued AS3350 filter IC. Due to its normalization between the control inputs and the parallel switch, the Setonix Synth Marsupial is a unique filter that can surprise any artist when patching it up. With that being said, let’s jump into the build.

Let's Get This Build Going..

Starting off with the build of this module, we will work on the backside of the PCB first. You will want to solder the 2×5-pin power header, 3-pin Series selection header, and two 25k multi-turn trimmers.

Be careful not to hold the iron on the parts for that long as you can release or damage some of the pre-soldered SMD components.

Don’t forget to place the plastic shunt over two of the three pins of the 3-pin header–”BP” will normalize Filter A’s Bandpass output to the Series switch, while “LP” will normalize Filter A’s Lowpass output to the same.


Neutral Labs NERMAL – DIY Build

Neutral Labs NERMAL - DIY Build

In the world of modular synthesis, there are many companies that offer distortion modules, but few of them really stand out. The Neutral Labs NERMAL is a destructive 3 layer distortion module that is able to modulate frequencies in the audio range to produce some rather unexpected harmonics. 

Known primarily for the desktop synth ELMYRA, the NERMAL is Neutral Labs first stab at eurorack and from what we can tell, it won’t be their last. We were anxious to get our hands on this build and learn all about its unique abilities. 

The Kit and where to get it (in the U.S.)

After seeing a few demos of the NERMAL, we knew we had to track one down. We ordered up from our friends over at Synthcube and within a few days it arrived safe and sound. Upon cracking the box open we were shocked to see the care in separating the components into “sections” or smaller packaging.

Neutral Labs really made it easy to keep the parts from getting all mixed up. They even state on their build document that one needs to go through one bag of parts at a time so that you won’t lose parts or have to double check resistor values. This was pretty rad that they were thinking of the builder.


Reverse Landfill Veratrum – DIY Build

Reverse Landfill Veratrum - DIY Build

Reverse Landfill’s modules never cease to amaze us and lo and behold they have done it again with the Veratrum; a noise and texture voice with brutal chaos. What is it you ask?

The Veratrum was a intership project between Reverse Landfill‘s own Martijn Verhallen and Freek / FRUKU. It took over 4 months to develop and in the end the Veratrum Noise Module was born. 

Veratrum contains 5 oscillators that go through a “pseudo” ring modulator and this in turn creates chaotic drones and swarming sounds. It has 2 audio outputs (square swarm & filtered) and one LFO output which when used at really low frequencies, blips and clicks seemingly are on the attack. 

Reverse Landfill Logo
Completed Front - Veratrum

The Reverse Landfill Veratrum eurorack module also features two touch pads that control the volume and pitch of two oscillators. Its unique look and cryptic control surface mirror that of its brethren modules produced by Reverse Landfill. Now let’s get on with the build shall we?

Links and more links…

Below are a series of links that have been provided by Reverse Landfill to help assist with the use, building and buying of the Veratrum.

Of course, we are here for you as well if you have any questions while building the module. Just hit us up on our Contact Page.