Dreadbox Dysmetria - DIY Build

Known for their unique and limited edition synths, Dreadbox has done it again with their latest synth, the Dysmetria. A two part analog groove synthesizer, the Dysmetria has a lot going on in a small 42hp footprint. Since we just completed the Dreadbox Dysphonia, it only seemed natural to take the Dysmetria on right after for our second build of the fall season.

As described by Dreadbox, “Dysmetria uses a subtractive synthesis mode, where 2 VCO’s and a White Noise Generator are summed up into a 2-pole Filter (Low Pass or Band Pass). Then a simple VCA follows. Only 2 Decay envelopes are available, one for the Amp and one for the Filter or the VCOs. Also the powerful FM circuit, helps a lot with its percussive sound”.

Let’s get on with the build….

The Dysmetria kit is rather extensive and consists of a lot of components. You will want to utilize several tools for the build itself. Make sure you have a good iron and plenty of solder. A multimeter to help measure values will also come in very handy.

~ Quick Links ~

Dreadbox Dysphonia – DIY Build

Dreadbox Dysphonia - DIY Build

As the summer months begin to subside and the fall weather moves in, we found ourselves going through our extensive list of kits to finally run across a kit we totally forgot about. Made by Dreadbox, the Dysphonia was billed as a single run, limited edition Full Voice Synthesizer
with Open Architecture.

Being that we have a soft spot for Dreadbox’s limited edition synths, we decided to take this build on as our first build of the fall. At 42hp, the Dreadbox Dysphonia is a little beast with patching in mind. We pulled the kit down from the shelf and jumped right in.

The kit (currently sold out) consists of a lot of jacks (x46), some slide pots (x8), regular pots (x13) and a few other odds and ends. It is a quick and easy build but it requires some patience when working with the jacks. As tedious as it is to place and solder these, it is apart of the process.

Thankfully, Dreadbox supplied the builder with this complete assembly guide to help you through the process.

fiN Studios

Tag: sound source