4MS Atoner Eurorack Module - DIY Build
For our latest eurorack build, we take on the mystical Atoner by 4MS Company. This little beast is only available as a kit that can either be ordered from 4MS directly or through other DIY module shops. We picked up ours from the gang out at SynthCube and dove right into the build.
-
- 4MS Atoner – Front Panel
-
- 4MS Atoner – Side View – Right
-
- 4MS Atoner – Rear View
-
- 4MS Atoner – Side View – Left
As for the build itself, it was relatively straight forward thanks to the extensive BOM and assembly guide that were provided with the 4MS Atoner kit. Where the build can wonder into the intermediate build category is with the tight ground wiring and navigation of confined spaces (see photos). With that being said, make sure your iron is clean and primed correctly as you don’t want to go into this build with a dirty iron or a dull tip. As for aesthetics, we loved the graphic design on the panel but didn’t care for the knobs that were supplied with the kit. They looked like generic cheap knock off Davies clones, so we chose our own orange Davies Clones to give our 4MS Atoner a little more flavor.
