Month: December 2017

fiN Studios and MST Modules!

Want to pick up some new MST modules to add to your rack?  We are proud to have these amazing modules in our studio and we are happy that the team at Synthrotek does as well. Check em out! Click the link below and let them know that we sent ya!


4MS RCD Breakout Module Time-lapse Build

Time-lapse video of the 4MS RCD Breakout Kit

We decided to take on the DIY kit of the 4MS RCD Breakout module which connects to the Rotating Clock Divider (RCD).

It was an pretty easy build as long as you have the patience for the intricate soldering of the individual ribbons in the power cable.  Make sure to also pay special attention to have the switches are set.  Once we were done, we hooked it up to our Synthrotek TST module to test the power cable and we were good to go. 

Note: Ribbons 13-16 are not used and you can pull them down carefully and cut them off. 

 

Next up is the 4MS RCD build – stay tuned!

~ f I N


fiN Studios and Synthrotek!

We are proud to announce that as of December 1, 2017 we have joined forces with Synthrotek based out of Portland, Oregon!  

We are huge fans of their modules and have to say that their customer service is top notch.  In previous posts, we put together some DIY builds of some of their amazing modules. As time passes and we continue building, we will make sure to record the build and review all of the modules that we purchase.  

If you are interested purchasing any of their modules, click on the banner below and tell them that fiN Studios sent ya.